Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
gcross
Posts: 195
Registered: ‎01-11-2001
Message 1 of 1 (220 Views)

iFeature Emboss Problem-Sheet metal -IV Ultimate 2012 SP2 64

220 Views, 0 Replies
11-01-2012 11:32 AM

I need help to revise a square emboss iFeature so I can add radii that will be an appriate size embossing a sheet metal part it's inserted into. I'm not sure where I got it (CBLISS maybe?).

 

Right now the edges of the positive side of the emboss have a tiny radius (as if coined in) & there seems to be no control over it in iFeature dialog box when editing. I cannot edit the radii at all.The negative side is free of any radii so I can add radii to suit. How do you edite the IDE to fix this (ide file attached)?

 

Gary

 

IV Ultimate 2012 SP2 64

Product Design Suite Ultimate 2014
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.