Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
rgruychev
Posts: 233
Registered: ‎11-24-2005
Message 1 of 2 (94 Views)

iassembly x=Table replace

94 Views, 1 Replies
03-24-2014 06:34 AM

When I Place new ipart in assembly and make iassembly i have  for ipart  x=Table replace (pic1)

But when i have exist part in assembly  and make ipart and after this iassembly (without Place) x=Table replace missing. (p2)

How can i have x=Table replace in iassembly  without used Place from exist part->ipart

 

*Expert Elite*
mcgyvr
Posts: 6,939
Registered: ‎12-01-2004
Message 2 of 2 (88 Views)

Re: iassembly x=Table replace

03-24-2014 06:37 AM in reply to: rgruychev

If a part was placed into an assembly BEFORE that part was made into an ipart you can do a "component..replace" and replace the part with the new ipart member. Then you will be able to replace one member with another. 

 

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

-------------------------------------------------------------------------------------
2015 Product Design Suite Ultimate
Windows 7 64 bit
Core i7 4820k processor (OC'd to 4.4Ghz), Nvidia GTX 770, 16G RAM


Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.