Inventor General Discussion

Reply
Distinguished Contributor
Ray_P
Posts: 151
Registered: ‎05-29-2003
Message 1 of 3 (205 Views)
Accepted Solution

i part factory

205 Views, 2 Replies
12-17-2013 06:59 AM
Hello does any one know of a way to mirror an I-part in the part factory table. I have searched and tried and sure would be nice. When a left hand part is required in a model there is not an easy way to mirror a factory part. I have recently found that if I derive in the parent factory part rather than the child component I can get better results. I set the parent part to desired configuration and update then suppress link in the mirror part. This works well but to create an I-Factory assembly it is not feasible as I cannot use table replace feature in the I-Assembly. Any help would be greatly appreciated. Thanks

Hi Ray,

It's pretty simple. Please see the attached iPart. The file is in IV2010 format.

Best Regards,

Igor.

Distinguished Mentor
IgorMir
Posts: 506
Registered: ‎08-02-2003
Message 2 of 3 (182 Views)

Re: i part factory

12-17-2013 05:00 PM in reply to: Ray_P

Hi Ray,

It's pretty simple. Please see the attached iPart. The file is in IV2010 format.

Best Regards,

Igor.

Web: www.meqc.com.au
Distinguished Contributor
Ray_P
Posts: 151
Registered: ‎05-29-2003
Message 3 of 3 (164 Views)

Re: i part factory

12-18-2013 06:36 AM in reply to: IgorMir
Thanks this helped I had to resolve some issues with the flat pattern errors but it does work. Thanks to IgorMir
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.