Community
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"accu-cad" <Good
href="mailto:accu-cad@velocity.net">accu-cad@velocity.net> wrote in
message
href="news:f129c90.-1@WebX.maYIadrTaRb">news:f129c90.-1@WebX.maYIadrTaRb...
Morning all,
I created a compression spring ipt. now I am trying to
located it in my iam. (non adaptive) With no flat usable surfaces it seems
rather difficult to locate. It is suppose to rest around a shaft between a
spring pin and a sheetmetal part. The spring pin is supposed thru a shaft.
That is a bugger to locate to as well. Do I just place it close and ground
it.? This does not seem correct. Any ideas? Same question for the spring
pin.
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"accu-cad" <Good
href="mailto:accu-cad@velocity.net">accu-cad@velocity.net> wrote in
message
href="news:f129c90.-1@WebX.maYIadrTaRb">news:f129c90.-1@WebX.maYIadrTaRb...
Morning all,
I created a compression spring ipt. now I am trying to
located it in my iam. (non adaptive) With no flat usable surfaces it seems
rather difficult to locate. It is suppose to rest around a shaft between a
spring pin and a sheetmetal part. The spring pin is supposed thru a shaft.
That is a bugger to locate to as well. Do I just place it close and ground
it.? This does not seem correct. Any ideas? Same question for the spring
pin.