Community
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"accu-cad" <Good
href="mailto:accu-cad@velocity.net">accu-cad@velocity.net> wrote in
message
href="news:f129c90.-1@WebX.maYIadrTaRb">news:f129c90.-1@WebX.maYIadrTaRb...
Morning all,
I created a compression spring ipt. now I am trying to
located it in my iam. (non adaptive) With no flat usable surfaces it seems
rather difficult to locate. It is suppose to rest around a shaft between a
spring pin and a sheetmetal part. The spring pin is supposed thru a shaft.
That is a bugger to locate to as well. Do I just place it close and ground
it.? This does not seem correct. Any ideas? Same question for the spring
pin.
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"accu-cad" <Good
href="mailto:accu-cad@velocity.net">accu-cad@velocity.net> wrote in
message
href="news:f129c90.-1@WebX.maYIadrTaRb">news:f129c90.-1@WebX.maYIadrTaRb...
Morning all,
I created a compression spring ipt. now I am trying to
located it in my iam. (non adaptive) With no flat usable surfaces it seems
rather difficult to locate. It is suppose to rest around a shaft between a
spring pin and a sheetmetal part. The spring pin is supposed thru a shaft.
That is a bugger to locate to as well. Do I just place it close and ground
it.? This does not seem correct. Any ideas? Same question for the spring
pin.
Can't find what you're looking for? Ask the community or share your knowledge.