Inventor General Discussion

Inventor General Discussion

Reply
*Ade
Message 1 of 2 (42 Views)

I Can't Get Rid of Tangency Lines in .idw

42 Views, 1 Replies
12-15-2002 07:46 PM
Hi All

I have an .idw of a box section framework. It's driving me nuts because I
can't get the tangency lines to not display. The box is unchecked on the
edit view pop up. I could go through the drawing and turn off the visability
but that would take ages. I have tried re-applying the design view but to no
avail.

Can anybody help a Brit in turmoil.

Adrian Danvers
CAD Engineer
Isoma Conveyors Ltd
Derbyshire
England
*A., Kirk
Message 2 of 2 (42 Views)

Re: I Can't Get Rid of Tangency Lines in .idw

12-17-2002 12:20 AM in reply to: *Ade
Can you post the file to CF? It would help us see what was going on.


"Ade" wrote in message
news:54B237F3C17295760EAF1264745C0B82@in.WebX.maYIadrTaRb...
> Hi All
>
> I have an .idw of a box section framework. It's driving me nuts because I
> can't get the tangency lines to not display. The box is unchecked on the
> edit view pop up. I could go through the drawing and turn off the
visability
> but that would take ages. I have tried re-applying the design view but to
no
> avail.
>
> Can anybody help a Brit in turmoil.
>
> Adrian Danvers
> CAD Engineer
> Isoma Conveyors Ltd
> Derbyshire
> England
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.