Inventor General Discussion

Inventor General Discussion

Reply
*Norris, Charlie
Message 1 of 2 (144 Views)

I can't change the size of my obround punch with or without SP1

144 Views, 1 Replies
11-18-2002 08:33 AM
I am only able to pick from the 4 item list but I can't enter a value. In
5.3 it worked but the preview was screwed up, the slots would show up in
some strange places.

Thanks
Charlie Norris
*Adams, Brad
Message 2 of 2 (144 Views)

Re: I can't change the size of my obround punch with or without SP1

11-18-2002 11:26 PM in reply to: *Norris, Charlie
I found that I had to modify the the obround.ide file so that I can enter in
my own value. Here are the steps I took to modify the file.
1. open the obround.ide file
2. start the Edit iFeature command.
3. under the Size Parameters section change the Limit style from List to
None for the length and width parameter.
4. pick Apply
5. save and close the file.
Now when you insert the iFeature you will be able to enter in any size for
the slot.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.