Inventor General Discussion

Reply
Member
smg5101
Posts: 3
Registered: ‎11-02-2012
Message 1 of 2 (201 Views)

HUD

201 Views, 1 Replies
11-02-2012 01:51 PM

I can't seem to turn on the dynamic input. I followed the advice to go through Tools-Application Options - Sketch Tab, but then it references a 'Settings' box that doesn't seem to exist (see the attached screen shot). Is there another way to get around this problem, or is there some other option that needs to be turned on?

 

Thanks,

Smg5101

*Expert Elite*
cwhetten
Posts: 1,090
Registered: ‎09-03-2008
Message 2 of 2 (199 Views)

Re: HUD

11-02-2012 01:59 PM in reply to: smg5101

Dynamic input is not available in Inventor 2009.  It was introduced in 2011 or 2012, I think.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.