Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
SophieSmith
Posts: 108
Registered: ‎07-13-2012
Message 1 of 2 (180 Views)
Accepted Solution

How to use shortcuts without +Enter

180 Views, 1 Replies
12-19-2012 10:18 AM

Hi,

I was used to using Shortcuts like

i for iproprietes,

l for line

M for measurements…

Now that i had to reinstall Inventor,

Most of all my Sort cuts have to be followed by an Enter..

i.e

i+Enter for ,

L+Enter for line,

Etc.

The new shortcuts where not entered with an Enter.

How can i fix this ?

 

Thanks!

Sophie

Hi  SophieSmith,

 

I  think this is the issue, but I might be mistaken:

 

Tools tab Options panel Customize button

 

Look for the Use default multi-character Command Aliases option and check that it is not selected.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

*Expert Elite*
Curtis_Waguespack
Posts: 3,002
Registered: ‎03-08-2006
Message 2 of 2 (171 Views)

Re: How to use shortcuts without +Enter

12-19-2012 11:01 AM in reply to: SophieSmith

Hi  SophieSmith,

 

I  think this is the issue, but I might be mistaken:

 

Tools tab Options panel Customize button

 

Look for the Use default multi-character Command Aliases option and check that it is not selected.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.