Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
amartin.r
Posts: 33
Registered: ‎07-24-2013
Message 1 of 3 (1,332 Views)
Accepted Solution

How to update automatically physical properties before saving

1332 Views, 2 Replies
01-31-2014 03:35 AM

Hi,

Currently, when I export my drawing, there are the mass, volume and area in the title block.

But several times, when I export my drawing it's indicated "N/A", I must go to the part and update the physical properties.

 

There is a tip for update automatically the physical properties ?

 

Thanks.

In the Application options on the General tab there is a checkbox for "Update physical properties on save".
Is that checked? Would that suffice?

Update_physical_properties.png

*Expert Elite*
-niels-
Posts: 1,627
Registered: ‎06-20-2006
Message 2 of 3 (1,323 Views)

Re: How to update automatically physical properties before saving

01-31-2014 04:06 AM in reply to: amartin.r

In the Application options on the General tab there is a checkbox for "Update physical properties on save".
Is that checked? Would that suffice?

Update_physical_properties.png


Using IV2014 Pro SP2 - upd.1, Win7-64bit
Active Contributor
amartin.r
Posts: 33
Registered: ‎07-24-2013
Message 3 of 3 (1,316 Views)

Re: How to update automatically physical properties before saving

01-31-2014 04:27 AM in reply to: -niels-

Arf it was so easy ! I wanted to do harder !

 

Thank you,

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.