Inventor General Discussion

Inventor General Discussion

Reply
Contributor
amartin.r
Posts: 25
Registered: ‎07-24-2013
Message 1 of 3 (674 Views)
Accepted Solution

How to update automatically physical properties before saving

674 Views, 2 Replies
01-31-2014 03:35 AM

Hi,

Currently, when I export my drawing, there are the mass, volume and area in the title block.

But several times, when I export my drawing it's indicated "N/A", I must go to the part and update the physical properties.

 

There is a tip for update automatically the physical properties ?

 

Thanks.

In the Application options on the General tab there is a checkbox for "Update physical properties on save".
Is that checked? Would that suffice?

Update_physical_properties.png

*Expert Elite*
-niels-
Posts: 1,547
Registered: ‎06-20-2006
Message 2 of 3 (665 Views)

Re: How to update automatically physical properties before saving

01-31-2014 04:06 AM in reply to: amartin.r

In the Application options on the General tab there is a checkbox for "Update physical properties on save".
Is that checked? Would that suffice?

Update_physical_properties.png


Using IV2014 Pro SP2 - upd.1, Win7-64bit
Contributor
amartin.r
Posts: 25
Registered: ‎07-24-2013
Message 3 of 3 (658 Views)

Re: How to update automatically physical properties before saving

01-31-2014 04:27 AM in reply to: -niels-

Arf it was so easy ! I wanted to do harder !

 

Thank you,

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.