Inventor General Discussion

Inventor General Discussion

Reply
Contributor
amartin.r
Posts: 25
Registered: ‎07-24-2013
Message 1 of 3 (723 Views)
Accepted Solution

How to update automatically physical properties before saving

723 Views, 2 Replies
01-31-2014 03:35 AM

Hi,

Currently, when I export my drawing, there are the mass, volume and area in the title block.

But several times, when I export my drawing it's indicated "N/A", I must go to the part and update the physical properties.

 

There is a tip for update automatically the physical properties ?

 

Thanks.

In the Application options on the General tab there is a checkbox for "Update physical properties on save".
Is that checked? Would that suffice?

Update_physical_properties.png

*Expert Elite*
-niels-
Posts: 1,575
Registered: ‎06-20-2006
Message 2 of 3 (714 Views)

Re: How to update automatically physical properties before saving

01-31-2014 04:06 AM in reply to: amartin.r

In the Application options on the General tab there is a checkbox for "Update physical properties on save".
Is that checked? Would that suffice?

Update_physical_properties.png


Using IV2014 Pro SP2 - upd.1, Win7-64bit
Contributor
amartin.r
Posts: 25
Registered: ‎07-24-2013
Message 3 of 3 (707 Views)

Re: How to update automatically physical properties before saving

01-31-2014 04:27 AM in reply to: -niels-

Arf it was so easy ! I wanted to do harder !

 

Thank you,

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.