Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
Karol-Or
Posts: 265
Registered: ‎11-28-2011
Message 1 of 2 (169 Views)
Accepted Solution

How to show thread lines in a slice operation

169 Views, 1 Replies
09-09-2013 12:18 AM

After a slice operation i have to make a sketch and complete lines.

For example, if i slice in the middle of a threaded hole, in the slice i don't see the thread lines, i just see as if there was a hole.

Hi,

 

Showing thread edges in slice views is not supported. As a workaround you can use a Section view with a very small section depth (e.g. 0.001).

 

Hope this helps,

 

Oto Kaleja

Autodesk

Employee
okaleja
Posts: 63
Registered: ‎12-13-2006
Message 2 of 2 (157 Views)

Re: How to show thread lines in a slice operation

09-09-2013 02:04 AM in reply to: Karol-Or

Hi,

 

Showing thread edges in slice views is not supported. As a workaround you can use a Section view with a very small section depth (e.g. 0.001).

 

Hope this helps,

 

Oto Kaleja

Autodesk

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.