I created a derived part and I broken the link with its parent. Is there a way to relink the two parts?
Autodesk Inventor 2011
Thanks in advance.
Solved! Go to Solution.
Next time Suppress Link rather than Break Link.
VBA guys... Help?
Reposted this question to the 'Customization' group:
You might try opening an old version from before you broke the link.
I haven't checked - but I sure hope so.
I expect Break Link to do exactly what it says.
Sorry, I should have been more clear.
Yes, break link should do as expected. I was hoping that in 2015 we might have a better way to relink to a part file.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!