Inventor General Discussion

Inventor General Discussion

Reply
Member
3 Posts
0 Kudos
Registered: ‎03-15-2011
Post 1 of 5

How to make the cut in a drill bit?

1563 Views, 4 Replies
03-25-2011 06:02 AM
Hello Everyone,
I am drawing an adjustable drill stop. I have basically chamfered a cylinder to create a point. I know what the sweep profile looks like, I just cannot seem to angle the plane to be tangent with the chamfer. Any suggestions?

-Max

 

 

IV2011 Professional 32-Bit
*Expert Elite*
28,589 Posts
2,120 Kudos
Registered: ‎04-20-2006
Post 2 of 5

Re: How to make the cut in a drill bit?

03-25-2011 06:09 AM in reply to: Zenjashi

You title says cut a drill bit.
Description says a adjustable drill stop.

Can you provide pictures of similar real part?
I'm not sure what you are after.

Can you attach the ipt file here?

 

 

Did you get this problem sorted out http://forums.autodesk.com/t5/Autodesk-Inventor/Disobediance/m-p/2953006

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
3,002 Posts
1,702 Kudos
Registered: ‎03-08-2006
Post 3 of 5

Re: How to make the cut in a drill bit?

03-25-2011 06:37 AM in reply to: Zenjashi

Hi Zenjashi,

 

You can find an example of a drill bit profile in the practice drawing PDF on sheet 11 at this link:

http://inventortrenches.blogspot.com/2011/03/modeling-practice-drawings-for-inventor.html

 

You'll create the profile on the end of the shaft, and then use the Coil tool to cut the profile at the desired pitch and length. Then you can use the Circular Pattern tool and pattern the cut 2 times to complete the other side. You'll want to place the chamfer on the end after making the coil cuts.

 

If I have a chance I'll post an example later.

 

I hope this helps.

 

Best of luck to you in all of your Inventor pursuits,

Curtis

http://inventortrenches.blogspot.com/

 

 

 



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





*Expert Elite*
3,002 Posts
1,702 Kudos
Registered: ‎03-08-2006
Post 4 of 5

Re: How to make the cut in a drill bit?

03-25-2011 06:49 AM in reply to: Curtis_Waguespack

Hi Zenjashi,

 

Here is the part file to use as an example.

 

I hope it helps,

Curtis

http://inventortrenches.blogspot.com/

 

 

 



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Valued Contributor
60 Posts
2 Kudos
Registered: ‎05-01-2010
Post 5 of 5

Re: How to make the cut in a drill bit?

05-06-2012 10:08 AM in reply to: Curtis_Waguespack
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post