hi, I can't make a spring moving according to other parts' behaviour. I use Inventor 12. can anybody help by examining it step by step? by the way I sent two photos (scanned by Microsoft Security Essentials-no problem), the spring in the photos was made by design accelerators-as compression spring. I want from spring to move with the other parts but it doesn't. For instance when I pull the blue part down, blue part, and the spring go the into of each other. Thanks in advance
I would make the spring myself with a Parameter called Height and then Animate Parameter in Inventor Studio Environment or create a Spring Force in Dynamic Simulation Environment.
Dr. All of us that have spent time on this Discussion Group know that this question comes up at least 1 a week. Autodesk must also know this too. Don't you think that they should add this feature into Inventor. Yes we all know it can be done and I'm sure a lot us have our special spring already made that we use. But with all the questions about this, Autodesk should put a generated spring that is driven with parameters. My 2 cents.
Autodesk should put a generated spring that is driven with parameters. My 2 cents.
There is an feature enhancement suggestion forum over here.
Autodesk obviously knows how to do it - the Spring Force in Dynamic Simulation is trivial to animate as a visual spring.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!