Inventor General Discussion

Inventor General Discussion

Reply
Contributor
sinus19
Posts: 25
Registered: ‎08-24-2012
Message 1 of 2 (137 Views)

How to Cut a Pipe at 45deg?

137 Views, 1 Replies
09-24-2012 02:40 PM

Hello,

I have some Pipe that I've created using the Frame Geanerator and im trying to cut the top of the pipe at a 45deg but i cant wrap my head around on how to do it? Any help would be much appreciated, thanks

*Expert Elite*
blair
Posts: 4,156
Registered: ‎11-13-2006
Message 2 of 2 (126 Views)

Re: How to Cut a Pipe at 45deg?

09-24-2012 03:04 PM in reply to: sinus19

A simple sketch on one of the Origin work planes with a project of the end face of the pipe, then create a triangular shape with the correct angle with Extrude - Cut - Both directions should work. 

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.