Inventor General Discussion

Inventor General Discussion

Reply
New Member
JBFarmer
Posts: 1
Registered: ‎11-27-2002
Message 1 of 2 (95 Views)

How can I import Autocad files to inventor

95 Views, 1 Replies
11-26-2002 12:29 PM
I'm trying to import dwg files from autocad 2002 to Inventor 5.3 but can't figure out how. Help!
*Sam_Hochberg
Message 2 of 2 (95 Views)

Re: How can I import Autocad files to inventor

11-26-2002 01:02 PM in reply to: JBFarmer
Whether you're in a part or drawing, make sure the Sketch button is
pushed in, and at the bottom of the Sketch panel bar you should see
"Insert AutoCAD file." Use the Options button instead of immediately
hitting Open to make sure end points are being constrained, etc. If
you don't see .dwg as a type of file to open, make sure Volo View
Express 2 is installed.
You can also use the Open command on .dwgs.


JBFarmer wrote:

> I'm trying to import dwg files from autocad 2002 to Inventor 5.3 but
> can't figure out how. Help!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.