Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Does anyone know why I can't create a hole with an NPT thread. I can create
the hole and then apply the thread, but then it does not show in the hole
table in the IDW. Just seemed strage to me that there was only a small
subset of threads that could be applied direct to the hole when it was
created.
If you are using the hole tool, use the thread tool after you create the
hole and you will be able to add the NPT threads (the threads and the hole
will be separate features). If you are extruding a circle in a sketch to
create the hole, add a face angle to the hole and the NPT threads will be
selected by default when you use the thread tool.
Yep. But it's been that way since the beginning. Don't know why...
-Sean
"Stephen" wrote in message
news:E6435034AFE98CD8A063DF575E94E165@in.WebX.maYIadrTaRb...
> Does anyone know why I can't create a hole with an NPT thread. I can
create
> the hole and then apply the thread, but then it does not show in the hole
> table in the IDW. Just seemed strage to me that there was only a small
> subset of threads that could be applied direct to the hole when it was
> created.
>
> Thanks
>
> Stephen
>
>
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")