Inventor General Discussion

Reply
*Sofia Grave
Message 1 of 2 (86 Views)

Hole table

86 Views, 1 Replies
11-19-2009 04:54 AM
Hej to all

I need to change the high of a head hole countersinck hole. That as a fixed
hight of 2,5 and I need 2,8

Thanks
sofia
*Expert Elite*
dan_inv09
Posts: 2,318
Registered: ‎12-12-2006
Message 2 of 2 (86 Views)

Re: Hole table

11-19-2009 08:55 AM in reply to: *Sofia Grave
Isn't a countersunk hole defined by the diameter and angle? Where are you trying to put in the depth?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.