Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
timmy.stalnacke
Posts: 50
Registered: ‎06-04-2012
Message 1 of 2 (278 Views)

Hole note without pitch?

278 Views, 1 Replies
11-09-2012 07:16 AM

is it possible to create a hole note without pitch.
i use standard thread in most cases so i just want the thread to be shown in the holenote tool on drawings (like M8 not M8x1,25)
any ideas?

 

Best regards.

*Pro
sbixler
Posts: 1,949
Registered: ‎09-15-2003
Message 2 of 2 (239 Views)

Re: Hole note without pitch?

11-11-2012 12:25 PM in reply to: timmy.stalnacke

The source for this data is the spreadsheet named Thread.xls, located in the Design Data\XLS\<localization>\ folder.  If you don't know where this is, look in your application options > File tab, and also in your Project (which can overrule the application options).

 

Typically, thread callouts are pulling from the Custom Thread Designation column, so you could customize your Thread.xls spreadsheet by making it read the way you want.  As you will see in the spreadsheet, there are a variety of pitches and classes for each thread size, so you could even delete all the extra choices that you don't use, leaving one of each size.  Or, add a sheet (and make it Sort Order - 1) with just your selections.

 

Hope that helps,

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!