Inventor General Discussion

Reply
*Mark Yorns
Message 1 of 1 (71 Views)

Hole note format

71 Views, 0 Replies
08-02-2004 10:15 AM
I posted a question last week and replied to it with more information. I thought people may pay less attention to a post if a reply is posted. If I don't get a response from this posting, I will quit bugging everyone. I created a new sheet in threads.xls for NPSM threads by copying the NPT worksheet. The NPSM threads show up as an option when I apply it to a hole in the part. So far, so good. However, when I place a hole note in the drawing the format is incorrect. I tried adding the NPSM to the pitch column, but that did not work. My final results was 1/4-18 NPSM NPT-2A! I don't even have a class of thread column in the new worksheet. Can anyone help me with where the information of the notes comes from and how I can modify it? TIA.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.