Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
karthur1
Posts: 4,223
Registered: ‎04-27-2005
Message 1 of 5 (136 Views)

Hole Note does not update after I change the part

136 Views, 4 Replies
11-28-2012 05:44 AM

Using 2013 sp1.1

 

After I change the hole size in the part, the callout in my hole note does not update. (crazy, I know).

 

Watch this video.

 

If I pull a new hole note after the change, it has the correct dimension. But, if I change the hole size again, this new hole note does not update.

 

I put the part on a new idw and it updates correctly, so somehow the idw is hosed.

 

 

Kirk A.

Windows 7 x64 -12 GB Ram
Intel i7-930 @ 3.60ghz
nVidia GTS 250 -1GB (Driver 301.42)
INV Pro R2013, SP1.1
Vault Basic 2013

*Expert Elite*
Cadmanto
Posts: 3,296
Registered: ‎12-07-2011
Message 2 of 5 (132 Views)

Re: Hole Note does not update after I change the part

11-28-2012 05:55 AM in reply to: karthur1

Kirk,

Couple of thoughts.

Did you try a complete rebuild of the drawing after the update?

Also what happenes if you use that same part and create a completely new drawing?  Does that drawing update?

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

*Expert Elite*
karthur1
Posts: 4,223
Registered: ‎04-27-2005
Message 3 of 5 (128 Views)

Re: Hole Note does not update after I change the part

11-28-2012 06:19 AM in reply to: Cadmanto

"Same part in new drawing"... it updates correctly (see my original post).

 

"Complete rebuild of the drawing"....  Its greyed out in the idw.  A rebuild all of the ipt after the change doesnt help either.

Valued Contributor
34mark713
Posts: 77
Registered: ‎02-03-2006
Message 4 of 5 (60 Views)

Re: Hole Note does not update after I change the part

08-21-2014 06:06 AM in reply to: karthur1

Sorry to bring up an old message...but did you find an answer to this?  I am using Inventor 2014 (all service packs installed) and I just had the same issue as the video you placed.  Edited a hole in the part, but the .hole note did not update.  Just wondering if I am missing something.

 

Thanks for any help

 

Mark

Employee
t_pcoll
Posts: 59
Registered: ‎12-11-2006
Message 5 of 5 (34 Views)

Re: Hole Note does not update after I change the part

09-04-2014 01:03 AM in reply to: 34mark713

Hi Mark,

 

can you please send me the dataset (IPT and IDW) which exhibits this problem? That would help me a lot to see where the problem is.

 

Thanks

Ladislav

 

ladislav(dot)pcola@autodesk(dot)com

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.