Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
drguitarum2005
Posts: 196
Registered: ‎10-08-2012
Message 1 of 3 (144 Views)
Accepted Solution

Hiding Features in One View

144 Views, 2 Replies
11-29-2012 08:56 AM

Hey Yall,

   I am making a multiview drawing with isometric of a certain sheet metal part. Due to manufacturing reasons, they have to make the part longer than necessary to get a bend in it then I will have them shear off the extra. Is there a way I can show the multiview and flat pattern WITH the extra material and show the isometric WITHOUT that extra? In the model I remove the excess with a cut but I don't know how to suppress a feature for one view and not another.

 

Thanks.

*Pro
jletcher
Posts: 1,946
Registered: ‎05-18-2011
Message 2 of 3 (143 Views)

Re: Hiding Features in One View

11-29-2012 09:04 AM in reply to: drguitarum2005

Put the extra material in the flat pattern only. this way the part is right and the flat pattern is what you need.

 

See attached file 2012


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Distinguished Contributor
drguitarum2005
Posts: 196
Registered: ‎10-08-2012
Message 3 of 3 (124 Views)

Re: Hiding Features in One View

11-29-2012 12:43 PM in reply to: jletcher

Thanks! That did it...

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.