I am trying hard to loft this. i cant understand why it would not?
Can any of you figure this out for me, please.
Solved! Go to Solution.
Solved! by ccarreiras. See the answer in context.
You need a loft, but not as you are thinking, i guess.
Its better do one part and then make a circular pattern to achive all part
I dont have Inv 2013, so i 'm sending you the model in step format.
But i can explain how to do it, if you will.
It's a little moere then this.
First objective: create the surface with loft.
1 - Create a construction plane (chose the central axis and a poin of the octahedron near your "vertical" skecth2)
2 - Open sketch2 and copy the geometry
3 - Create new sketch (sketch8 in the image) and paste the geometry. Transform the copyed geometry in "block" to maintain the form intact.
project the points from both tetahedrons and conect the copyed geometry to these two projected points.
4- Now you have two sketches (your in red iand the new in blue), you can perform the loft: open the loft tool, change to surface mode and chose both sketches.
Now you have a nice surface. End of first objective.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!