help with holes

[Anonymous]

i have this part thats extruded to a curved surface. there are screw tubes
on each end. on the end with the curve, it took me 3 workplanes per tapped
hole to get it the way i want. i was just wondering if anyone could see a
better / easier way of doing this. the files are in CF if anyone can take a
look.

thanks

Matt

[Anonymous]

Matt, could you offset one workplane past the edge, project the holes
centers to that sketch then make the individual holes, adjusting the depth
to where you want it?
~Larry

"Matt Stocking" wrote in message
news:C39DC699DB950FF423F3D92EBBA55155@in.WebX.maYIadrTaRb...
> i have this part thats extruded to a curved surface. there are screw tubes
> on each end. on the end with the curve, it took me 3 workplanes per tapped
> hole to get it the way i want. i was just wondering if anyone could see a
> better / easier way of doing this. the files are in CF if anyone can take
a
> look.
>
> thanks
>
> Matt
>
>

[Anonymous]

Hello Matt,
Where is CF ?

[Anonymous]

Customer files is where we post any attachments, you can find it by
following the appropriate link below.

newsreader

news://discussion.autodesk.com/autodesk.autocad.customer-files

Web
http://discussion.autodesk.com/WebX?14@182.7dacauBhof6.1@.ee940b5
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program

http://www.MyMcad.com/KWiK/Mcad.htm

"Mike_Barker" wrote in message
news:f143229.1@WebX.maYIadrTaRb...
> Hello Matt,
> Where is CF ?