Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am helping a friend making drawings for a
sculpture made of concrete and glass. The concrete block has "twisted" sides and
I need to cut the glass flush with the side. Either extrude from the middle to
each side or extrude beyound the sides and then cut. Because of the twist I
cannot make a workplane on the sides.
I am at loss.
Peer could this be a challenge in the WC
:-)
I have placed the files in CF under the name
Listaverk.zip
I am helping a friend making drawings for a
sculpture made of concrete and glass. The concrete block has "twisted" sides
and I need to cut the glass flush with the side. Either extrude from the
middle to each side or extrude beyound the sides and then cut. Because of the
twist I cannot make a workplane on the sides.
I am at loss.
Peer could this be a challenge in the WC 🙂
I have placed the files in CF under the name
Listaverk.zip
I am helping a friend making drawings for a
sculpture made of concrete and glass. The concrete block has "twisted" sides
and I need to cut the glass flush with the side. Either extrude from the
middle to each side or extrude beyound the sides and then cut. Because of
the twist I cannot make a workplane on the sides.
I am at loss.
Peer could this be a challenge in the WC 🙂
I have placed the files in CF under the name
Listaverk.zip
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")