Inventor General Discussion

Reply
*Jesse
Message 1 of 1 (33 Views)

Help on Import Please!

33 Views, 0 Replies
11-18-2002 12:00 AM
Did anyone figure out a solution to the fact that with SP1 installed you can
not import anything into viz without it crashing.This is very, very, very
(edited) . It worked fine in 5.3, then in 6 the selection box was screwed, and
now in SP1 it is all screwed and crashes as soon as you click. Please Help.
I use Inventor to VIZ all the time or at least did until now. Thanx a
million
Jesse
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.