Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
nickv02
Posts: 68
Registered: ‎03-23-2012
Message 1 of 4 (357 Views)
Accepted Solution

Help making sheet metal part

357 Views, 3 Replies
10-12-2012 12:57 PM

I have a 14 gage sheet metal part that follows the profile in the attached picture.  7/8" legs with a 1/16" offset.  Because it's 14 gage, the contour flange won't create it.  I need it to be able to be turned in to a flat pattern so that I may export it to a .dxf.  Is there another way to make this that will allow me to flat pattern it?  I have a couple of pieces like this where the offset is very slim, so I am looking for a way to do all of them like this.

 

Hi nickv02,

 

Attached is an example that might give you a hint. I didn't see any information on what version of Inventor you're using, but hopefully you can open an Inventor 2010 file (that's the oldest version I have Installed these days.)

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

*Expert Elite*
mcgyvr
Posts: 7,247
Registered: ‎12-01-2004
Message 2 of 4 (335 Views)

Re: Help making sheet metal part

10-12-2012 01:22 PM in reply to: nickv02

That profile is just incorrect. Its not made like that in real life unless its a stamping operation which Inventor cannot properly define the flat pattern for.

 

How is this part fabricated?

 

Model the 2 faces then use "bend" to connect them if press braked.

 

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

-------------------------------------------------------------------------------------
2015 Product Design Suite Ultimate
Windows 7 64 bit
Core i7 4820k processor (OC'd to 4.4Ghz), Nvidia GTX 770, 16G RAM


*Expert Elite*
Curtis_Waguespack
Posts: 3,000
Registered: ‎03-08-2006
Message 3 of 4 (334 Views)

Re: Help making sheet metal part

10-12-2012 01:22 PM in reply to: nickv02

Hi nickv02,

 

Attached is an example that might give you a hint. I didn't see any information on what version of Inventor you're using, but hopefully you can open an Inventor 2010 file (that's the oldest version I have Installed these days.)

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Valued Contributor
nickv02
Posts: 68
Registered: ‎03-23-2012
Message 4 of 4 (319 Views)

Re: Help making sheet metal part

10-12-2012 01:34 PM in reply to: Curtis_Waguespack

Inventor 2013, forgot that.

 

It's a stamping procedure.  You're right, I was going about it the wrong way and drew it incorrectly.

 

Curtis, that example is excellent, thank you for your help!

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.