Inventor General Discussion

Inventor General Discussion

Reply
Mentor
Talayoe
Posts: 292
Registered: ‎10-17-2011
Message 1 of 2 (402 Views)

Helical Gear Display in drawings

402 Views, 1 Replies
06-05-2012 02:01 PM

Hello,

 

I have a beef. When showing a gear in an inventor drawing they look good, but showing a helical gear SUCKS! The display, I realize, is very realistic to what you would see if you held the gear in front of you at this view point or that.

 

Problem is, I put a helical gear drawing on the shop floor and they machinist wonder why I have two rows of teeth on the gear (since it shows the front face and the helix'd gear teeth).

 

Any way to remove said offending gear teeth?

 

Tks!

-Randy

----------------------
Inventor 2015 PDS
Product Support
bobvdd
Posts: 577
Registered: ‎11-23-2005
Message 2 of 2 (375 Views)

Re: Helical Gear Display in drawings

06-08-2012 01:44 PM in reply to: Talayoe

Can you show us a picture of what you got? Here is a drawing I came up with.

I don't see anything "offending".

 

helical.JPG

 

Bob

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.