Inventor General Discussion

Reply
Contributor
nicu_bogd
Posts: 21
Registered: ‎03-25-2013
Message 1 of 2 (124 Views)
Accepted Solution

hatch and sheets

124 Views, 1 Replies
11-13-2013 11:59 AM

Hello. Using ISO.idw template I created into a sheet a Sketch which contains a hatch. Now I want to delete that hatch and I don't find anywhere how to delete it.

 

The second problem is this: I want to create in multiple sheets the same drawing but with small differences. How to copy a drawing from a sheet to another sheet. I press right click on the first sheet and i press Copy but there's no Paste button.

Hi nicu_bogd,

 

 

If you want to remove a hatch,

  1. Edit a sketch that contains the hatch.
  2. Click Fill/Hatch Region and select the hatch.
  3. Disable Hatch.

 

You can't copy sheets within a drawing. Please follow these steps,

  1. Create a new drawing.
  2. Go to the source drawing.
  3. Shift-select or Control-select the sheets you want, then copy.
  4. Go back to the new drawing.
  5. Paste.

You can still copy Views within a drawing.

 

 

I hope the above answers your question.

 

Thanks.

 

 

Product Support
inchul.lee
Posts: 67
Registered: ‎09-15-2008
Message 2 of 2 (99 Views)

Re: hatch and sheets

11-15-2013 06:10 AM in reply to: nicu_bogd

Hi nicu_bogd,

 

 

If you want to remove a hatch,

  1. Edit a sketch that contains the hatch.
  2. Click Fill/Hatch Region and select the hatch.
  3. Disable Hatch.

 

You can't copy sheets within a drawing. Please follow these steps,

  1. Create a new drawing.
  2. Go to the source drawing.
  3. Shift-select or Control-select the sheets you want, then copy.
  4. Go back to the new drawing.
  5. Paste.

You can still copy Views within a drawing.

 

 

I hope the above answers your question.

 

Thanks.

 

 



Inchul Lee
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.