Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
nickhowe
Posts: 36
Registered: ‎02-28-2012
Message 1 of 6 (560 Views)
Accepted Solution

Half Section View Through Centent Centre Profiles

560 Views, 5 Replies
11-20-2012 02:32 AM

I can't sem to get a Half Section View through extruded Centent Centre parts such as channels, pipes etc.?

 

Any Ideas?

 

Nick

Application Options > Assembly > Section all parts

*Pro
sbixler
Posts: 1,968
Registered: ‎09-15-2003
Message 2 of 6 (554 Views)

Re: Half Section View Through Centent Centre Profiles

11-20-2012 04:02 AM in reply to: nickhowe

In an assembly, or in a drawing?

Active Contributor
nickhowe
Posts: 36
Registered: ‎02-28-2012
Message 3 of 6 (548 Views)

Re: Half Section View Through Centent Centre Profiles

11-20-2012 04:18 AM in reply to: sbixler

In an assembly visualy on screen as I rotate. The parts creted from scratch are section viewable but the content centre stuff not. Check image.

 

Nick

*Pro
sbixler
Posts: 1,968
Registered: ‎09-15-2003
Message 4 of 6 (542 Views)

Re: Half Section View Through Centent Centre Profiles

11-20-2012 04:22 AM in reply to: nickhowe

Application Options > Assembly > Section all parts

Active Contributor
nickhowe
Posts: 36
Registered: ‎02-28-2012
Message 5 of 6 (538 Views)

Re: Half Section View Through Centent Centre Profiles

11-20-2012 04:26 AM in reply to: sbixler

Thanks for saving my hair and sanity!!

*Pro
sbixler
Posts: 1,968
Registered: ‎09-15-2003
Message 6 of 6 (524 Views)

Re: Half Section View Through Centent Centre Profiles

11-20-2012 05:07 AM in reply to: nickhowe

You're welcome.  Sanity is in short supply, so let's save as much as we can...

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.