Inventor General Discussion

Inventor General Discussion

Reply
New Member
R-P-T-0
Posts: 1
Registered: ‎12-28-2012
Message 1 of 2 (182 Views)

GRILL

182 Views, 1 Replies
12-28-2012 03:28 AM

Greetings All.

 

The part i make is from solid model>The part needs to be in sheet metal.What steps do i use to make as sheet metal part and have option to flatten part.I am learning with Education version

 

Thanks to any one who can help

 

Ross

*Expert Elite*
cbenner
Posts: 3,421
Registered: ‎04-06-2010
Message 2 of 2 (174 Views)

Re: GRILL

12-28-2012 04:04 AM in reply to: R-P-T-0

Hi,  I'm afraid I can't help you with the sheet metal.  But I might make afriendly suggestion that you put sheet metal into your Subject line in some way, so that readers looking through the forums will know right away that this is a sheet metal question.  You are more likely to attract the attention of someone who can help you out.

 

Good luck!

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cadtipstricks.wordpress.com//


   

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.