Inventor General Discussion

Reply
Contributor
nateuk05
Posts: 25
Registered: ‎10-19-2008
Message 1 of 3 (138 Views)

green dots

138 Views, 2 Replies
12-11-2012 10:56 AM

ok i know this comes up all the time but the green dots for the mid and end points no longer show up in my sketch.  i have read a lot of posts about this and have checked the constraint options and all of them are selected.  im not sure what i should try from here.  thanks for the help.

Distinguished Mentor
john.retzlaff
Posts: 935
Registered: ‎11-03-2003
Message 2 of 3 (128 Views)

Re: green dots

12-11-2012 11:18 AM in reply to: nateuk05

They will only show up when you are adding a sketch element.

 

John Retzlaff
*Expert Elite*
JDMather
Posts: 27,486
Registered: ‎04-20-2006
Message 3 of 3 (100 Views)

Re: green dots

12-11-2012 04:00 PM in reply to: nateuk05

You do not mention if you also checked Constraint Persistence.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.