Inventor General Discussion

Inventor General Discussion

Reply
Contributor
LawrenceFHoughton
Posts: 16
Registered: ‎11-11-2008
Message 1 of 4 (295 Views)
Accepted Solution

Geometric tolerances -Zero's,comma's and points

295 Views, 3 Replies
11-28-2012 03:18 PM

Glad I caught this error in Inventor 2013. 

 

See attached

Product Support
mercerc
Posts: 261
Registered: ‎10-29-2008
Message 2 of 4 (242 Views)

Re: Geometric tolerances -Zero's,comma's and points

11-30-2012 05:46 AM in reply to: LawrenceFHoughton

Thank you for your posting. In reviewing the issue it looks to be related to the dimension style you are using. From my testing it looks like you were using a DIN standard which gives the result you posted in the document. If you use an ANSI dimension style using a point it is not reproducible. But the comma does exhibit the same results.

 

For the time being you will need to be aware of the dimension style you’re using. I will log this with development.

 

Once again thank you for bring this to our attention. 

 

Contributor
LawrenceFHoughton
Posts: 16
Registered: ‎11-11-2008
Message 3 of 4 (225 Views)

Re: Geometric tolerances -Zero's,comma's and points

11-30-2012 08:25 AM in reply to: mercerc

I was using ISO std.

Product Support
mercerc
Posts: 261
Registered: ‎10-29-2008
Message 4 of 4 (222 Views)

Re: Geometric tolerances -Zero's,comma's and points

11-30-2012 08:33 AM in reply to: LawrenceFHoughton

Different standard but the results are the same as DIN vs ANSI.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.