Inventor General Discussion

Inventor General Discussion

Reply
Contributor
oneshortplanck
Posts: 12
Registered: ‎07-07-2011
Message 1 of 3 (126 Views)

Generate files iAssembly

126 Views, 2 Replies
04-17-2012 08:01 AM

I have an assembly with around 120 variants in it.

 

I am getting a little annoyed having to click the OK button when asked:

"Do you want to save changes to 122.iam" and its dependants"

 

is there any way to set the default to OK?

(other than setting an electric motor and a poking device up)

 

i would like to leave it over night etc...

 

thanks in advance

Contributor
oneshortplanck
Posts: 12
Registered: ‎07-07-2011
Message 2 of 3 (60 Views)

Re: Generate files iAssembly

10-08-2013 11:47 PM in reply to: oneshortplanck
BUMP
*Expert Elite*
Cadmanto
Posts: 3,244
Registered: ‎12-07-2011
Message 3 of 3 (47 Views)

Re: Generate files iAssembly

10-09-2013 05:59 AM in reply to: oneshortplanck

The only place I thought this message might be (which I wasn't holding my breath) would have been in the application options under the prompts taband it wasn't there.

I know what you are talking about and this is a pain.  Unless there is an iLogic routine that does this I am not sure there is a way around other then to keep doing what you are doing.

 

check.PNGIf this solved your issue please mark this posting "Accept as Solution".

Or if you like something that was said and it was helpful, Kudoskudos.PNG are appreciated. Thanks!!!! :smileyvery-happy:

 

New EE Logo.PNG

Inventor.PNG     vault.PNG

Best Regards,
Scott McFadden
Inventor Professional 2013
(Colossians 3:23-25)

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.