Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
gsmith9810
Posts: 115
Registered: ‎12-28-2012
Message 1 of 2 (116 Views)

Fudging an Existing Drawing

116 Views, 1 Replies
01-21-2013 02:36 PM

I was just asked to take an existing drawing and "fudge" the drawing with new dimensions to create a variation.

 

So I over rode the dimensions and edited the title block date/drawn by.

 

I replaced the model reference HOWEVER...

 

...I have not been able to CHANGE the title or drawing number (despite the fact that the replaced model has the iProperties that I want).

 

I suspect this is due to the fact that the drawing is set to NOT update (I have red lightning bolt).

 

Can I get away with doing what I want without recreating the whole drawing?

-------------------------------------------------------
Gary Smith
Inventor Product Design Suite 2013sp2
Windows 7sp1 64-bit
nVidia Quadro 2000
Distinguished Contributor
gsmith9810
Posts: 115
Registered: ‎12-28-2012
Message 2 of 2 (105 Views)

Re: Fudging an Existing Drawing

01-21-2013 03:19 PM in reply to: gsmith9810

Nevermind, just re-did the drawing...

-------------------------------------------------------
Gary Smith
Inventor Product Design Suite 2013sp2
Windows 7sp1 64-bit
nVidia Quadro 2000
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.