Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
gsmith9810
Posts: 115
Registered: ‎12-28-2012
Message 1 of 2 (111 Views)

Fudging an Existing Drawing

111 Views, 1 Replies
01-21-2013 02:36 PM

I was just asked to take an existing drawing and "fudge" the drawing with new dimensions to create a variation.

 

So I over rode the dimensions and edited the title block date/drawn by.

 

I replaced the model reference HOWEVER...

 

...I have not been able to CHANGE the title or drawing number (despite the fact that the replaced model has the iProperties that I want).

 

I suspect this is due to the fact that the drawing is set to NOT update (I have red lightning bolt).

 

Can I get away with doing what I want without recreating the whole drawing?

-------------------------------------------------------
Gary Smith
Inventor Product Design Suite 2013sp2
Windows 7sp1 64-bit
nVidia Quadro 2000
Distinguished Contributor
gsmith9810
Posts: 115
Registered: ‎12-28-2012
Message 2 of 2 (100 Views)

Re: Fudging an Existing Drawing

01-21-2013 03:19 PM in reply to: gsmith9810

Nevermind, just re-did the drawing...

-------------------------------------------------------
Gary Smith
Inventor Product Design Suite 2013sp2
Windows 7sp1 64-bit
nVidia Quadro 2000
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.