Inventor General Discussion

Reply
Mentor
PACDrafting
Posts: 587
Registered: ‎10-22-2007
Message 1 of 7 (184 Views)
Accepted Solution

Frame Generator Report

184 Views, 6 Replies
06-12-2012 09:54 PM

Is there any way in standard inventor to find what sketch is related to a frame generator member?

Open the Frame part, in the model browser, you could see the sketch in the browser's dot.

sketch.jpg

Product Support
jingy
Posts: 234
Registered: ‎10-14-2007
Message 2 of 7 (152 Views)

Re: Frame Generator Report

06-25-2012 08:32 PM in reply to: PACDrafting

Please  view the skill builder about Frame Generator.

http://usa.autodesk.com/adsk/servlet/item?siteID=123112&id=12193815

 



Yong Jing
Product Support Specialist
Frontline Technical Support, CSS. GCSO
Mentor
PACDrafting
Posts: 587
Registered: ‎10-22-2007
Message 3 of 7 (139 Views)

Re: Frame Generator Report

06-26-2012 12:10 AM in reply to: jingy

Thanks for your input.

 

But I'm afraid thats not what the question is.

Product Support
jingy
Posts: 234
Registered: ‎10-14-2007
Message 4 of 7 (129 Views)

Re: Frame Generator Report

06-28-2012 11:46 PM in reply to: PACDrafting

As you see, all the the frame generator part is published into Content Center, and saved at you idcl file at folder: C:\ProgramData\Autodesk\Inventor 2013\Content Center\Libraries.

 

After the part is published, there is no way to edit the sketch drawing which has combined with the published part.  You use CC editor to modify the parameters.

 



Yong Jing
Product Support Specialist
Frontline Technical Support, CSS. GCSO
Mentor
PACDrafting
Posts: 587
Registered: ‎10-22-2007
Message 5 of 7 (124 Views)

Re: Frame Generator Report

06-29-2012 12:48 AM in reply to: PACDrafting
Not talking about that sketch.

I'm after the sketch within the frame skeleton after the member gets assigned to a line on placement in an assembly.
Product Support
jingy
Posts: 234
Registered: ‎10-14-2007
Message 6 of 7 (122 Views)

Re: Frame Generator Report

06-29-2012 01:01 AM in reply to: PACDrafting

Open the Frame part, in the model browser, you could see the sketch in the browser's dot.

sketch.jpg



Yong Jing
Product Support Specialist
Frontline Technical Support, CSS. GCSO
Mentor
PACDrafting
Posts: 587
Registered: ‎10-22-2007
Message 7 of 7 (114 Views)

Re: Frame Generator Report

06-29-2012 03:46 AM in reply to: PACDrafting
Thanks. It's the driven sketch I'm after. As shown in your picture.
Thanks for replying.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.