style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
wrote in message
calling out threaded holes on a drawing I was would like to change the default
call out from fraction to decimal.
Example: 1/4-20 to .250-20
Also I would like to remove the class of thread. Is this
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!