Bob,
In the IDW environment you could use the flat pattern and make a sketch
associative to it. Simply insert the flat pattern into the IDW and then
highlight the view befor epicking the sketch button.
Or for that matter you could even do a sketch in the assembly mode
associated with the part if I am not mistaken. Though I have never done it /
needed it.
Was I following what you needed?
John T
"Bob" wrote in message
news:0AED89E9102B0EAFD1921BEE5EB72DE8@in.WebX.maYIadrTaRb...
> Can I use Flat Metal Patterns from a sheet metal design as a sketch and
> add tabs for match marks, etc.
>
> Bob
>