My flat pattern of a sheet metal part fails when I added strenthening Press ribs to the middle of the part using an iFeature.
I know Inventor is not capable of flattening embossed sheetmetal but is there a way to still get the flat pattern & ignore the formed areas?
Seems to me I was able to add some model features in the past like bosses, extruded holes KO's etc & I could still make a flat pattern.
I know I can use derived part to do it but that adds complications.
IV 2012 SP2
Use sheet metal Punch tool for those ribs. (a Punch tool is a special iFeature)
Is it as simple as adding a center mark to the Press Rib ide file &moving the ide into the punch folder from the other folder or do I need to create a Press rib tool from scratch? This is a compicated iFeature tool & I'm not sure about being able to reproduce it.
A little more to it (not much) than adding center mark and location.
When you create the iFeature there is a tickbox for Punch tool.
I always create my iFeatures as Punch tools whether they really are punches or not.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!