Flat pattern features -> a folded part

[yannicknielsen]

Hey guys

I have made a sheet metal part based only on a contour flange (so far).

My sketch consists of two lines and a spline.

It works fine and I can make flat pattern and everything - Nothing is wrong.

I have now cut out a feature in the flat pattern (And yes, I know it states that it is added exclusively to the flat pattern)

I would like to know if there is a way to fold it again so the feature is on the folded part

I cannot project flat pattern or use cut across bend - Because it is a spline, according to inventor.

Best regards

Yannick NIelsen

[-niels- · Accepted solution]

Does the "unfold/refold" method work?

[yannicknielsen]

Oh. I didn't think of that! - Yes, that worked perfectly fine 🙂