Inventor General Discussion

Inventor General Discussion

Reply
*Grunwald, Mike
Message 1 of 1 (23 Views)

flange wont edit

23 Views, 0 Replies
12-09-2002 04:43 AM
I want to edit a flange using the dialog box that pops up. Normally I get a
green wire frame that previews my choices. I'm not getting that, and the ok
button stays greyed out. I can enter different lengths for the flange, but
no ok button. I can post to CF if there is no obvious problem here.
Mike
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.