Inventor General Discussion

Inventor General Discussion

Reply
New Member
1 Posts
0 Kudos
Registered: ‎02-07-2013
Post 1 of 2
Accepted Solution

Flange sheet metal part from inner edges

286 Views, 1 Replies
02-07-2013 06:32 AM

I would like to ask any support to how can I solve the problem I have to face.

I have a metal sheet part. In the middle of it there is a square shape cutting. 

I would like to create a flange to get the final flat pattern as you can see in the attached file nemed "flat pattern.png".

Adjust your corner setting for the flange.

corner flange-1.JPG

 

Apply a CORNER CHAMFER to the edges of the flanges.

corner flange2.JPG

 

Your flat pattern should look like this.  You may have to tweak your flange corner settings (or GAP settings) to achieve the desired final part.

corner flange3.JPG

Distinguished Mentor
515 Posts
203 Kudos
Registered: ‎10-22-2008
Post 2 of 2

Re: Flange sheet metal part from inner edges

02-07-2013 07:22 AM in reply to: ccsmith25

Adjust your corner setting for the flange.

corner flange-1.JPG

 

Apply a CORNER CHAMFER to the edges of the flanges.

corner flange2.JPG

 

Your flat pattern should look like this.  You may have to tweak your flange corner settings (or GAP settings) to achieve the desired final part.

corner flange3.JPG

Mike Patchus

Inventor 2012 SP3 ~ Vault Pro 2013
==================
Lenovo D20 Workstation Intel Xenon E5640@2.67GHz (2)
Win 7, 24gb RAM, NVIDIA Quadro FX 3800

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below. :smileyhappy:
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!