How would you machine this? That's a clue on how to do the fillet. It looks
like you have converging edges... (please post the model). If the edges
converge, then move the EOP marker above the ribs. Fillet, then
repair/restructure the ribs.
Dennis
--
Dennis Jeffrey, Inventor 9/10 Professional user
Autodesk Inventor Certified Expert
Autodesk Product Consulting and Training
Omicron Electronics - Center for Design Excellence
http://www.omicronmi.com
http://www.design-excellence.com
260-312-6188
wrote in message news:4858496@discussion.autodesk.com...
Please see the attached image, I cannot get all of the internal and external
edges of the ribs to fillet. Some do, some don't. I am using a variable
radius, zero at the work point positions, 0.5 at the other end of the edge.
Even if I specify a radius down to 0.01mm IV still reports the radius is too
large. Thanks.