Inventor General Discussion

Inventor General Discussion

Active Member
8 Posts
0 Kudos
Registered: ‎11-01-2010
Post 1 of 4

Fillet Command Crashing Program

311 Views, 3 Replies
02-18-2011 02:15 PM

Anyone else having problems when trying to create a fillet, and it crashes the program? In my case, I'm trying to create a .004" fillet along edges created using an extruded/cut spline. It tells me the radius cannot be created - try using a smaller radius... and then when I hit either edit or cancel, the program crashes.

15 Posts
0 Kudos
Registered: ‎06-29-2010
Post 2 of 4

Re: Fillet Command Crashing Program

02-19-2011 11:32 AM in reply to: mnoramczyk

Your graphics card driver is more than likely in need of some attention. check ou this FAQ on the CADlinecommunity - you will need to register with the site, but registration is free

*Expert Elite*
28,589 Posts
2,120 Kudos
Registered: ‎04-20-2006
Post 3 of 4

Re: Fillet Command Crashing Program

02-19-2011 05:59 PM in reply to: mnoramczyk

Attach the file that exhibits this behavior here for others to test on their machines.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
59 Posts
26 Kudos
Registered: ‎02-14-2005
Post 4 of 4

Re: Fillet Command Crashing Program

02-21-2011 09:44 AM in reply to: mnoramczyk

Please attach or email the file that shows the problem to me - along with the version of Inventor you are using.





Gerald Hochenauer(
Inventor Principal Software Engineer

Manufacturing Group
Autodesk, Inc.


Gerald Hochenauer
Senior Principal Engineer, Inventor
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post