Inventor General Discussion

Reply
Active Member
kckoons
Posts: 7
Registered: ‎01-30-2003
Message 1 of 2 (95 Views)

File open ceates a cycle???

95 Views, 1 Replies
11-04-2002 03:15 AM
I am trying to open an .iam file that a pack and go was performed on. When I try to open this file, I get the message that opening this file will cause a cycle and inventor asks me to open another. Any help or thoughts would be helpful. Thanks
*Dotson, Sean
Message 2 of 2 (95 Views)

Re: File open ceates a cycle???

11-04-2002 05:33 AM in reply to: kckoons
Is it the file resolution dialogue?  for
example, is it asking you to find a file and giving you a thumbnail view and a
bunch of path information?  If so then you need to brush up on project
files.  The pack and go should have created a project file for use with the
packed project.  Did you load this project file first?


--
Sean Dotson, PE

href="http://www.sdotson.com">http://www.sdotson.com

remove all #s from
email
-----------------------------------------


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
I
am trying to open an .iam file that a pack and go was performed on. When I try
to open this file, I get the message that opening this file will cause a cycle
and inventor asks me to open another. Any help or thoughts would be helpful.
Thanks
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.