Inventor General Discussion

Inventor General Discussion

Active Member
Posts: 6
Registered: ‎11-26-2012
Message 1 of 2 (132 Views)

FEA analysis multiple assemblies help

132 Views, 1 Replies
12-05-2012 10:07 AM

So I have an assembly made up of several smaller assemblies and have constrained them in the main assembly but when I run the analysis, the interaction does not seem to exist.


An image has been displayed below, the pin should line up with the holes.


*Expert Elite*
Posts: 808
Registered: ‎10-23-2012
Message 2 of 2 (118 Views)

Re: FEA analysis multiple assemblies help

12-05-2012 12:09 PM in reply to: dwhamm

You've got constraints in the main assembly, but do you have contacts / constraints set up correctly in the Stress Analysis environment?


Product Design Suite Ultimate 2013, 2014, 2015

Workstation: i7-4770k / ASUS Z87-Pro / 16GB / 250 GB SSD / 1 TB HDD / 3 TB USB3 HDD / Radeon R9-270X 4GB
Laptop: Toshiba Satellite P755-S5269 (i7-2630QM / 8 GB / 250 GB SSD / 750 GB HDD / GT540M)

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.