Inventor General Discussion

Reply
Valued Contributor
jyothissurendran
Posts: 98
Registered: ‎08-27-2012
Message 1 of 1 (124 Views)

Family Table Editor !!!

124 Views, 0 Replies
09-19-2012 05:32 AM

I am upadting the family table in content center editor which meets our requirements. I stuck up on the columns for " Torsional rigidity modulus, Torsional Section modulus and Radius of gyration.

There is any esay option available to find out these values for pipe ? or It can be updated manually by following some equations ?

If its by equation, please advise what equation i can use ?

 

I got  some equations from internet to find out the above mentioned properties but with the same equations i tried for the  default library . the values are not matching.

 

Jyothis Surendran
Inventor Professional Suite 2010
Windows 7
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.